SV-15P Alcohol Parquet Adhesive

SV-15P is suitable for indoor bonding of wooden floors with small dimensions (up to max. 250 x 50mm) such as solid, stab, pre-finished, and on-end parquet, wood-plank, wood-block and
laminates.
Not suitable for wooden floors and multi-layer or ready to use parquet with large dimensions.
Therefor use MS-30P Parquet Adhesive or PU-20P 2-component Parquet adhesive.
Suitable for use on porous substrates such as concrete, screeds, wood, mosaic, chipboard and OSB Board (large particle size chipboard). Do not
use on pretreated wood.

SV-15P should be acclimatised to room temperature before installation.
Apply the adhesive to the surface by means of a suitable notched SOUDAL trowel N° 3. Do not apply more to the surface that can be covered with
parquet within 10 minutes. Slide the parquet onto the adhesive layer and tap into place or tamp down with a rubber hammer.
A minimum of 80% contact coverage is required to ensure a perfect adhesion. Loading the parquet with weights will improve the final bond strength. Wait at least 24 hours before sanding and finishing
the parquet. Uncured SV-15P may be removed from tools and
parquet with SOUDAL Adhesive cleaner. Cured adhesive must be removed mechanically.

– Never install to substrates, which are not protected against possible
rising damp.
– Do not apply the adhesive at temperatures below 15°C or above 25°C
– Minimum temperature of the substrate should be at least 15°C.
– Do not apply the adhesive when the relative humidity is above 75%.
– Never install onto a substrate which contains too much moisture or
onto substrates with a higher humidity value than recommended by
the wood supplier.
– Never install wood which is too dry (<7% humidity). This can expand at higher humidity or when the humidity rises and cause damage. - Do not install if the walls and ceilings of the area are not dry (e.g. after plastering or painting etc.) - Do not dilute the adhesive