– Easy to apply
– Acoustic and thermal insulator
– Wind- and waterproof (depending on the compression)
– No priming and finishing required
– Non-staining at joint edges
– Neutral, does not smell
– Expands to fill the gap and adapts to uneven substrates
– UV proof
– Filling of joints in constructions, prefabricated elements,
brickwork, concrete,
– Sealing between frames and walls, etc.
– Ideally suited for rain- and windproof sealing in concrete- and steal
constructions, timber constructions, brickwork, prefab constructions,
roof constructions
– Can be used both in interior (Soudaband Acryl) and exterior
(Soudaband Acryl BG-2 and BG-1) applications.
Soudaband Acryl is easy to apply. No special tools are required, the use of a spatula, knife or scissors and if necessary wooden wedges is enough.
Choose a corresponding Soudaband dimension after deciding the joint-width (see table). The joint edges should be parallel and free of dirt and/or rests of cement.
Take at least 1 cm extra when unwinding Soudaband. Start at the bottom in case of vertical joints (see fig. 1 and 2). Fix Soudaband with the
self-adhering side to one joint edge by means of a filling-knife.
Functionality of Soudaband is dependent on the compression;
– Compressed up to 25%; (driving) rain-tight, high sound insulation
– Compressed up to 35%; rain-tight, good sound insulation
– Compressed up to 50%; tight, good sound insulation
– Compressed up to 75%; water-repellent, dust and draught tight
