– Ready to use, no mixing required
– Remains flexible
– Single component ready to use system
– EC-1R Plus label: very low emission values
– Solvent free
– Contains no water
– Free of isocyanates
– Easy to apply
– Forms stable peaks when applied with a notched trowel or spreader comb
– Rapid cure and build up of final bond strength
– High final bond strength (according to EN14293)
– Remains permanently elastic
– Suitable for subfloor heating
– Avoids staining of the hands
SMX-30PLUS is a solvent, and water-free universal parquet adhesive based upon SMX Polymers. Suitable for indoor bonding of all types of wooden floors such as solid, stab, pre-finished, and on-end parquet, wood-planks up to 18cm wide, wood-block and laminates.
Suitable for use on porous and non-porous substrates such as mosaic, anhydrite, concrete, screeds, wood, chipboard and OSB Board (large
particle size chipboard) , including floors with underfloor heating.
SMX-30PLUS is also extremely suitable for bonding moisture sensitive wood onto moderately porous surfaces.
SMX-30PLUS should be acclimatised to room temperature before installation. Apply the adhesive to the surface by means of notched SOUDAL trowel N°11. For parquet sizes smaller than 60mm wide and 300mm long notched SOUDAL trowel N°3 is recommended. Do not apply more to the surface than can be covered with parquet within 40 minutes. Slide the parquet onto the adhesive layer and tap into place or tamp down with a rubber hammer.
A minimum of 80% contact coverage is required to ensure a perfect adhesion. Loading the parquet with weights will improve the final bond strength. Wait at least 12 hours before sanding and finishing the parquet.
Uncured SMX-30PLUS may be removed from tools and parquet with SOUDAL Adhesive cleaner. Cured adhesive must be removed mechanically.
– Never install onto substrates, which are not protected against possible rising damp.
– Do not apply the adhesive at temperatures below 15°C or above 25°C
– Minimum temperature of the substrate should be at least 15°C.
– Do not apply the adhesive when the relative humidity is above 75%.
– Never install onto a substrate which contains too much moisture or onto substrates with a higher humidity value than recommended by the timber supplier.
– Never install timber which is too dry (<7% humidity). This type of timber can expand at higher humidity or when the humidity rises and cause damage.
- Do not install if the walls and ceilings of the area are not dry (e.g. after plastering or painting etc.)
- Do not dilute the adhesive.
