– Easy to use and to apply
– Fast cure
– Wide application area, even in wet drill holes, under water and at
temp. as low as –10°C
– Styrene free (low odour)
– Cartridge re-usable by simply exchanging static mixer
– Watertight and impermeable fixing
– High chemical resistance
– Fire Resistance class F120 (M8-M30)
– European Technical Approval Option 1 for application in cracked and
uncracked concrete
– Emission in indoor air class A+
Securing of heavy loads in solid and hollow building materials. Pressure free anchoring even close to edges. Can be used as repair mortar.
– Drill hole at recommended depth
– Clean drillhole with brush and air pump thouroughly
– Screw static mixer onto cartridge
– Dispense the first 10 cm of the product to waste (on piece of
cardboard) until an even colour (dark grey) is achieved, and the
product is well mixed
– Solid stone: fill the drill hole from bottom up.
– Hollow brick: insert sleeve and fill it bottom up, so that the resin
is pressed through the tiny holes of the sleeve
– Insert anchoring rod with twisting left-right motion
– Inspect the drill hole for adequate filling
– Observe hardening time. Don’t move the anchoring rod during curing
– Leave the excess of product to cure as well.
– Remove it mechanically with hammer and chisel once cured
– Install component, applying the right torque
Cartridge:
280 ml cartridge for standard skeleton gun
380 ml for use with special two-component gun.
There is a risk of staining on porous substrates such as natural stone. On such substrates a preliminary compatibility test is recommended.
